vampvamp 发表于 昨天 10:07

3-axis coordinate round trip POST - TEST version

I created this using the MPMASTER version.
The NC data is accurate,
but I haven't been able to perform actual machining yet.

Please note that only six coordinates, G54 through G59, can be used for reciprocating machining.

From that point on, machining is sequential.










xinruyu369 发表于 昨天 11:44

带刀单，不错

mayzhang1024 发表于 昨天 12:08

谢谢分享，学习一下。

Ngdoankete 发表于 昨天 22:30

谢谢分享
页: [1]
查看完整版本: 3-axis coordinate round trip POST - TEST version