3-axis coordinate round trip POST - TEST version

vampvamp · 发表于昨天 10:07

I created this using the MPMASTER version.
The NC data is accurate,
but I haven't been able to perform actual machining yet.

Please note that only six coordinates, G54 through G59, can be used for reciprocating machining.

From that point on, machining is sequential.

MPMASTER_ZIGZAG.zip (56.26 KB, 下载次数: 20)

xinruyu369 · 发表于昨天 11:44

带刀单，不错

mayzhang1024 · 发表于昨天 12:08

谢谢分享，学习一下。

Ngdoankete · 发表于昨天 22:30

谢谢分享

		自动登录	找回密码
密码			立即注册

[分享] 3-axis coordinate round trip POST - TEST version

相关帖子

浏览过的版块