MasterCAM车床后处理 想要程序输出余量值 求ID号

爺¤de寵妃*

想要程序输出 这些余量值。求ID号  

Jebens

余量是stock

爺¤de寵妃*

Jebens 发表于 2022-11-22 10:02
余量是stock

留个联系方式吧 弄包烟抽抽

爺¤de寵妃*

Jebens 发表于 2022-11-22 10:02
余量是stock

能具体点儿吗  怎么输出这些余量值 到程序里面

qingg

打开没有改过的后处理就看有余量显示了

qingg

fmt "TOOL - "      4   tnote    #Note format
fmt "DIA. OFF. - " 4   toffnote #Note format
fmt "LEN. - "      4   tlngnote #Note format
fmt "TOOL DIA. - " 1   tldia$   #Note format
fmt "XY STOCK TO LEAVE - " 2  xy_stock #Note format
fmt "Z STOCK TO LEAVE - "  2  z_stock  #Note format
# --------------------------------------------------------------------------
fmt     4   year2       #Calculated year value
fmt     18  time2       #Capture 24-hour time value into 'time2' variable
fmt     19  hour        #Hour
fmt     20  min         #Minutes
year2 = year$ + 2000

#endregion

#region Tool comment, tool table, manual entry output
# --------------------------------------------------------------------------
# Tool Comment / Manual Entry Section
# --------------------------------------------------------------------------
ptoolcomment    #Comment for tool
      tnote = t$, toffnote = tloffno$, tlngnote = tlngno$
      if tool_info = 1 | tool_info = 3,
        sopen_prn, pstrtool, sdelimiter, *tnote, sdelimiter, *toffnote, sdelimiter, *tlngnote, sdelimiter, *tldia$, sclose_prn, e$

ptooltable      #Tooltable output
      sopen_prn, *t$, sdelimiter, pstrtool, sdelimiter, *tlngno$,
        [if comp_type > 0 & comp_type < 4, sdelimiter, *tloffno$, sdelimiter, *scomp_type, sdelimiter, *tldia$],
        [if xy_stock <> 0 | z_stock <> 0, sdelimiter, *xy_stock, sdelimiter, *z_stock],
        sclose_prn, e$
      xy_stock = 0  #Reset stock to leave values
      z_stock = 0   #Reset stock to leave values

爺¤de寵妃*

qingg 发表于 2022-11-22 14:26
fmt "TOOL - "      4   tnote    #Note format
fmt "DIA. OFF. - " 4   toffnote #Note format
fmt "LEN ...

感谢分享 好汉留下姓名